|
|
Post by mjuszczyk79 on Jan 6, 2011 8:22:23 GMT -5
Hi , Matt here. I've got streetrod. I put the dealy into effects loop and the sound stays more "mono" like behind the wall.
Don't know if it's normal but the difference in sound is too big...
I'll be greatful for advice from You guys.
Thanks, Matt
|
|
|
|
Post by shredheadjhj on Jan 6, 2011 9:14:04 GMT -5
First hint of advice, post in the right forum. There is a forum for all things "Street Rod".
What kind of delay are you using dude?
|
|
|
|
Post by mjuszczyk79 on Jan 6, 2011 11:57:58 GMT -5
Sorry , I'm a stranger here-didn't take the right forum...
First of all- when i push the effects loop button on, the sound, overdrive , all stay like "mono", very light like on the neck pickup. It doesn't matter if i turn the dealy or not. In that situtation it's impossible to practice for me cause I live in a flat, with neighbours all around- this sound is so poor... I don't know: is it right or I've got the amp damaged...
|
|
|
|
Post by sasquatch on Jan 6, 2011 13:40:52 GMT -5
Have you tried pushing the "Level" button next to the "Loop" button? Not sure if that would change anything if nothing is in the loop, but it might be worth a try.
|
|
|
|
Post by mjuszczyk79 on Jan 6, 2011 15:57:56 GMT -5
Yeah, I've tried. It seems to be difficult to live in the flat and practice with this amp. After the loop button is activated the sound stays really poor.... It really needs to be opened (the gain) to sounds good. I'm not sure if I'm right but hope the street rod is ok.
|
|
|
|
Post by sasquatch on Jan 7, 2011 11:07:39 GMT -5
I might suggest not getting too carried away with cranking the Channel Master and barely turning up the loop volume if that's in fact what you're doing. I don't have a Street Rod, I have a QR... but running the Chanel Master in the 9-10 o'clock range and then dialing up the Loop Volume to the desired sound level gets the best sound when you can't run the Loop Volume wide open. If you're really choking the volume in the loop section it can sound a bit weak. The same can be true if you're doing the opposite... cranking the Loop Volume and not dialing up the Channel Master past 8:30-9 o'clock.
|
|
|
|
Post by mjuszczyk79 on Jan 2, 2012 7:30:28 GMT -5
Hi guys, need avice. Got gibson with emg's, zakk wylde overdrive, wah, noise supressor.
Put the delay into the effects loop, the gate at the end , overdrive's output before 12.
When the volume is about 2 or more there is a lot of noise. Please let me know step by step how would you connect all the effects and what knobs on the back should be turned on.
Thanks a lot, Matt
All the best in 2012!
|
|
