|
|
Post by crustodd on Dec 19, 2009 20:28:39 GMT -5
I'm havin' a brain blank. If I'm running my QR at full power with TWO separate 2X12" 8 Ohm cabs, I should set the head for 4 or 8 Ohms? If I run a single 8 Ohm cab on half power I set the head at 4 Ohms? I apologize for my spat of stupidity.
T~
|
|
|
|
Post by metaltronixmike on Dec 20, 2009 8:58:37 GMT -5
4 ohms for both. Remember, the ohm setting on your QR can less than your cabinet(s), but never more. Two 8 ohm cabs @ full power = 4 ohms @ QR. One 8 ohm cab with QR at 1/2 power = 4 ohms. MM
|
|
|
|
Post by sasquatch on Dec 20, 2009 12:25:11 GMT -5
4 ohms for both. Remember, the ohm setting on your QR can less than your cabinet(s), but never more. Two 8 ohm cabs @ full power = 4 ohms @ QR. One 8 ohm cab with QR at 1/2 power = 4 ohms. MM +1 |
|
|
|
Post by crustodd on Dec 20, 2009 22:31:03 GMT -5
Thanks Gents
|
|
