|
|
Post by trendkill1168 on Jan 14, 2007 1:23:44 GMT -5
Ok, so I run my Pro Stock at 50 watts and I wanted to try out a couple of JJ KT88's that I have lying around vs. the quad of Sovteks that are already in it. Which set of tubes is the head running at 50 watts, the 2 inner or 2 outer? I would guess the 2 inner but I figured I better inquire. This way I can just swap in the 2 JJ tubes at 50 watts and give them a whirl.
|
|
|
|
Post by shreder75 on Jan 17, 2007 15:11:50 GMT -5
I beleive you're correct..the inner ones...
|
|
|
|
Post by n0fx on Jan 17, 2007 20:32:44 GMT -5
I don't think it matters two inners or two outers.
Then half the impedance switch on back. To switch to KT-88's
I believe you will need to change some resistor values to
run it long-term. Better check with Scott.
|
|
|
|
Post by trendkill1168 on Jan 19, 2007 14:32:07 GMT -5
Thanks guys, that's what I thought. Just wanted to make sure.
|
|
|
|
Post by iiimk on May 20, 2009 13:40:26 GMT -5
Does anyone know exactly which resistors and values to change them too? I'm about to acquire a Pro stock and wish to switch it from el34 to kt88s. Ive done some minor amp mods before so Im pretty confident with a soldering iron. If this is already posted somewhere else I apologize.
|
|
|
|
Post by jesusdriven on May 20, 2009 17:01:30 GMT -5
Ok, so I run my Pro Stock at 50 watts and I wanted to try out a couple of JJ KT88's that I have lying around vs. the quad of Sovteks that are already in it. Which set of tubes is the head running at 50 watts, the 2 inner or 2 outer? I would guess the 2 inner but I figured I better inquire. This way I can just swap in the 2 JJ tubes at 50 watts and give them a whirl. Leave in the inner two tubes and pull the outside tubes. |
|
