|
|
Post by chuckabooboo on Jan 11, 2007 21:59:26 GMT -5
Hey Guys, At Full Power, if you connect TWO, 16 ohm 4,12 Cabinets into your Quick Rod, would you set the amp ohms to 8 or 4 ohms??  I'm assumming 8ohms would be correct setting for full power and at HALF power, one would set the ohms to 4ohms or have I made a TOTAL JACKA$$ of myself? ? Thanks, CoonAss Chuck.................. |
|
|
|
Post by ballzdeep on Jan 13, 2007 7:22:50 GMT -5
You got it!
If you run 2 16 ohm cabs at half power set the QR for 4ohm's.
But for two 16 ohm cabs at full power sat at 16ohm's.
Good luck!
And have fun!!!
|
|
|
|
Post by chuckabooboo on Jan 13, 2007 8:05:37 GMT -5
You got it! If you run 2 16 ohm cabs at half power set the QR for 4ohm's. But for two 16 ohm cabs at full power sat at 16ohm's. Good luck! And have fun!!! Thanks for your input...... I found this article which cleared it up and re-inforced my pea brain: www.worldmusicsupply.com/ezine/amps/Marshall/default.asp |
|
|
|
Post by ballzdeep on Jan 13, 2007 8:15:31 GMT -5
If you go to the splawn amps page you can download the manual and it tell's you the diffrent ohm settings for full and half power. Its on page 10.
No Prob!
|
|
|
|
Post by Hacksaw on Jan 13, 2007 17:05:28 GMT -5
You got it! If you run 2 16 ohm cabs at half power set the QR for 4ohm's. But for two 16 ohm cabs at full power sat at 16ohm's. Good luck! And have fun!!! I bet this is a typo.. two 16 ohm cabs, full power set to 8 ohms on the amp. |
|
|
|
Post by Superchiks on Jan 16, 2007 13:29:57 GMT -5
Yeah - I think its a typo too. Two 4X12 16 ohm cabs full power =means 8 ohms on the amp
|
|
I'm assumming 8ohms would be correct setting for full power and at HALF power, one would set the ohms to 4ohms or have I made a TOTAL JACKA$$ of myself?
