Amp issues

[sfw]

Ok.  So a few weeks ago the power tubes in my amp decided to die.  I picked up a quad of JJ EL34s and a quad of Tung-Sol EL34s.  The JJs came in first, so I installed them.  I immediately noticed that the amp did not have the top end bite that it previously had.  When the Tung-Sols arrived, I went ahead and install those.  Set the bias to 32mA- where I usually like the amp to be.  For some reason, I'm still missing top end.  I've gone through all of the preamp tubes I have at the house, and nothing has given me back the highs.  I've also noticed that I've lost a bit of gain on the lead channel.  It's like someone put a low pass filter on the amp and clamped down on the high end.  I can bring the Treble and  Presence up, but it doesn't sound the same.  

Anyway... just looking for some thoughts and opinions.

[briman]

Didn't you post about turning on the amp without a load a couple weeks ago? Or was that someone else?
If it was you, I would have a tech look over everything. If it wasn't you, I would put in brand new pre amp tubes and see if it gets its bite back. If not.....take to tech.

[sfw]

Unfortunately, that was me.